Design

   Safe’s body is a single-layered steel construction. Access to side faces of the safe is protected by the design of walls or floor and concrete that fills free spaces of the created niche.
Internal door hinges allow a door to be opened by 90 degrees. The door is fixed in the body by 2 mobile girth rails, the locking mechanism is fixed by seven-level lock with the key that has a double bit. Over-all thickness of the door is 60 mm.

   Manual for the installation of built-in safe

   The deepening in the wall that will be used for the embedding of the safe should be done in such a way that the gap between its side faces and walls would be not less than 100 mm.
   The safe is placed into prepared deepening, then it should be leveled and fixed, for example with the help of wedges.
   Safe's position is checked by level: the door shouldn't neither open nor close spontaneously.
   After above-mentioned steps are fulfilled a free space between side faces of the safe and a wall should be filled with concrete or a cement solution.

   ATTENTION! While proceeding installation steps and during 2 days after cementation is finished the safe should be held closed.
   In the case of moist walls or at the embedding of the safe into a wall that separates two rooms with different temperature conditions in order to avoid the contact between it and humid environment and prevent the formation of condensate inside the safe it should be heat-isolated and waterproofed.